The J-48 VIP was shipped with the following lamps:
ACCELERATOR® VS-R™ Wolff® Model VAC75-T12-160W VS-R Bi-Pin
NEW!!! Velocity VS-R Recertification
| Part Number
| Part Descriptions for J-48 VIP
| Spectrum P/N
|
| P01057 |
Air Dam* (This is a piece of foam attached to the inside of the cover panels that is
used to route air flow) |
23443-01 |
| 24300-01 |
Ballast, (160W) |
24300-01 |
| P01068 |
Bronze Hinge Bushing* |
23470-01 |
| 20989 |
Capacitor, 75uF W/Stud |
20989 |
| 10070 |
Contactor (Relay) |
10070 |
| P01058 |
Cover Panel, all panels the same except power panel (customer may also
need the foam Air Dam that is applied to the inside of the cover) |
23444-01 |
| P01059 |
Cover Panel, (w/power cord cut-out) |
23444-02 |
| P01062 |
Cover Panel w/Decals* |
23444-05 |
| |
Dome (Orange) |
23841-02 |
| |
Dome Shroud (Blue) |
23842-01 |
| |
Fan, 6" (220 cfm) |
23570-01 |
| 10081 |
Fan Cooling (110cfm) |
10081 |
| P01662 |
Fan, Body (825cfm) |
22896-02 |
| 20592 |
Fan Relay |
20592 |
| P01056 |
Grill (all Grills are the same) |
23442-01 |
| P01070 |
Handle, Door |
23474-01 |
| P01172 |
Handle, Inside |
23896-01 |
| P01067 |
Handle, Outside |
23468-01 |
| P01054 |
Hardware Kit* (Complete) Kit contains eyewear, assembly plates, bronze hinge bushings, pins, inside
door handle and the various screws, nuts and washers needed to assemble the Sundome |
23432-02 |
| P01069 |
Hinge Locking Pin* |
23471-01 |
| 20080 |
Lamp Holder w/Starter |
20081 |
| 20081 |
Lamp Holder w/o Starter |
20080 |
| N/A |
Manual* |
23838-01 |
| |
Pedestal |
27604-01 |
| P01096 |
Profile, Trim |
23568-01 |
| P01097 |
Profile, Edge Cover |
23569-01 |
| 21400-02 |
Remote Control Bypass Plug (P00942) |
21400-02 |
| 23187-01 |
Remote Connection PCB |
23187-01 |
| N/A |
Schematic Packet* |
23402-01 |
| P01126 |
Silk-screened Profile, Left Door |
23700-01 |
| P01127 |
Silk-screened Profile, Right Door |
23700-02 |
| |
Speaker (Shipped in pairs) |
23469-01 |
| 20944 |
Starter K-12 |
20944 |
* Not shown
|
